M 4-22

[Great-Kazoo]

no threads on the end, how can you throw your suppressor on it?

[Irving]

Easy, send it to Tornado Tech (and pay more money and wait several months). Not that TT is over priced, just very busy.

[rtg]

no threads on the end, how can you throw your suppressor on it?

The barrel is turned down to 1/2 inch just run a 1/2-28 die on her and its done...

[Hoser]

The barrel is turned down to 1/2 inch just run a 1/2-28 die on her and its done...

Bad idea. Have a gunsmith do it in a lathe.

[rtg]

Bad idea. Have a gunsmith do it in a lathe.

They make a starter die that works good. not that big of a deal if the barrel is at 1/2 inch. I have access to a lathe so thats how I do mine..

[275RLTW]

Iron Ridge Arms in Longmont has done some for me in a few days. Total cost for cut, thread, & recrown was only $95

[Irving]

They make a starter die that works good. not that big of a deal if the barrel is at 1/2 inch. I have access to a lathe so thats how I do mine..

What method do you use to make sure the threads are perfectly concentric to the barrel? If not threaded perfectly, then you seriously risk a baffle strike and wasting all the money it cost you to obtain the suppressor.

[Hoser]

They make a starter die that works good. not that big of a deal if the barrel is at 1/2 inch. I have access to a lathe so thats how I do mine..

Assuming the bore is exactly in the middle of the barrel...

I hope it works out for you.