What did you do in the reloading room today?

[Hoser]

How long did the maintenance on both units take?

Couple hours total. Granted I made coffee, played in the snow with the hounds, ect. The 1050 is a pretty simple machine to tear all the way down.

[Great-Kazoo]

Couple hours total. Granted I made coffee, played in the snow with the hounds, ect. The 1050 is a pretty simple machine to tear all the way down.

It runs me an hour to do a complete tear down & service on the 1050. Looking at it, one would think it's a complex press. Once apart a few shafts, bearings etc, good clean up and inspection parts, fresh grease then back up and running. Dillon did a nice job on the 1050, reminds me of a motorcycle bottom end.

[Limited GM]

Tore down two of my 1050s all the way, cleaned them all up, repacked the bearings and reassembled. I was going to do the same to number three 1050, but got bored and went back to loading rifle ammo on my 550. 223 Ackley and 6 Grendel with Varget.

You were wise to not have me meet you at your house. Fugger.