Close
Page 1 of 3 123 LastLast
Results 1 to 10 of 23
  1. #1
    Gong Shooter hawk1's Avatar
    Join Date
    Mar 2010
    Location
    Denver
    Posts
    460

    Default Painting clean edges

    Ok... So I'm starting to finish another painting project (ha-ha-ha) and I have a question for the painting Pro's... On a lightly textured wall, what is the BEST WAY to tape so paint doesn't bleed under? I have tried painting the original color of the wall over the tape so IT bleeds under first...still paint gets under...I've tried a thin bead of caulking over the edge of the tape...still paint gets under... I've tried Blue tape and Frog tape and I still get spots where the paint bleeds under. My OCD will not allow me to just look past it and I didn't wanna spend hours with a model car paint brush going over the spots.

    So, can anyone help a guy out with some tips?!?

  2. #2
    Amateur meat smoker blacklabel's Avatar
    Join Date
    Feb 2005
    Location
    Greeley
    Posts
    6,557

    Default

    I'm interested too. We're about to paint our bedroom and I need all the help I can get.

  3. #3
    Machine Gunner KestrelBike's Avatar
    Join Date
    Jun 2012
    Location
    Omaha, NE
    Posts
    2,341

    Default Painting clean edges

    Best lame advice I can give is leave an unpainted margin to prevent bleed-over, then fill in the gap with a small brush (model car sized if necessary)

  4. #4
    A FUN TITLE asmo's Avatar
    Join Date
    May 2012
    Location
    Douglas County (Parker)
    Posts
    3,446

    Default

    I have the ninja skill - but it is an ancient secret.

    1) Put up your blue tape.
    2) Take the edge of a straight edge and score a VERY light line down the edge.
    3) Paint
    4) Take the tape up while the paint is actually still a bit wet.

    Works every time.
    What is my joy if all hands, even the unclean, can reach into it? What is my wisdom, if even the fools can dictate to me? What is my freedom, if all creatures, even the botched and impotent, are my masters? What is my life, if I am but to bow, to agree and to obey?
    -- Ayn Rand, Anthem (Chapter 11)

  5. #5
    Machine Gunner Jamnanc's Avatar
    Join Date
    May 2011
    Location
    Johnstown
    Posts
    1,671

    Default

    Blue tape with caulking apply the caulk with a tube which you wipe off with a wet finger clean off finger on a wet rag, make sure a little caulking seals the edge of the tape. Don't wait too long after painting to pull the tape, dry to touch.

  6. #6
    Machine Gunner Jamnanc's Avatar
    Join Date
    May 2011
    Location
    Johnstown
    Posts
    1,671

    Default

    Oh yeah, when you paint, don't mush it under the tape

  7. #7
    Grumpy Mountain Man crashdown's Avatar
    Join Date
    Dec 2009
    Location
    Tanaina Alaska
    Posts
    756

    Default

    Buy a quality brush and learn how to cut.
    Tape does not work on textured walls.
    Cutting in is faster and looks cleaner. Might need to water your paint down a bit to do it.
    Google up some videos on how to do it, it's really not hard.
    Last edited by crashdown; 02-17-2013 at 14:06.

  8. #8
    Machine Gunner Big Wall's Avatar
    Join Date
    Feb 2011
    Location
    Englewood, CO
    Posts
    2,153

    Default

    Quote Originally Posted by Jamnanc View Post
    Blue tape with caulking apply the caulk with a tube which you wipe off with a wet finger clean off finger on a wet rag, make sure a little caulking seals the edge of the tape. Don't wait too long after painting to pull the tape, dry to touch.
    This.

    My wife and I had a painting business for 9 years. It doesn't take much caulk. Caulk edge of tape. Wipe with finger and then wipe with a wet rag. Then paint. Don't press any harder than you have to and use quality brushes like Purdy. Only do a section as far as you can reach. Then pull the tape almost to where you stopped painting. Then do the next section. Don't use blue tape, it justs costs more and isn't needed unless you are taping a more delicate surface, like paper covered wood molding, or are leaving the tape in place for a few days. You can also paint the original color over the tape, but it is more time consuming. We would only do this when there was not a caulk color that matched the original paint color. If there was a lot of lines like this, there are caulk tubes that you can inject paint into and it mixes with the caulk as you squeeze it out.

    I'm just starting my 12 hr shifts for the week. If you would like some help I can stop by and give some advice thurs, fri or sat. Shoot me a pm.

    Here is a link to some of the work we did. Scroll down to teh bottom for pics of stripes and diamonds we have done. We aren't painters any more. The economy killed us, so don't think I'm giving you a sales pitch.

    http://www.flickr.com/photos/aspenleafpaintinginc/
    Mars is entirely inhabited by robots.

  9. #9

    Default Painting clean edges

    Quote Originally Posted by crashdown View Post
    Buy a quality brush and learn how to cut.
    Tape does not work on textured walls.
    Cutting in is faster and looks cleaner. Might need to water your paint down a bit to do it.
    Google up some videos on how to do it, it's really not hard.
    This. It takes practice, and its not something easily explained or shown for that matter but is way faster and you can cut a perfectly straight line with any sized brush once you learn it. Back when I was painting for a living the biggest thing I had to get across the new hires is to only dip the tip of the brush maybe 1/2" in the paint, slap it on the side of the Can a couple times, no scraping on the rim, then knock the initial excess off by doing a couple strokes on the wall before you start trying to draw a line. Ohh and hold the brush like a pencil you're drawing a line not clubbing baby seals.

    And for a quality brush try Purdy. I like the blue bristle ones in a 3" not sure the actually name/model but any paint store other than Home Depot type places will know what a "blue bristle" is. Expect to pay $30 or so for a descent brush.

  10. #10
    Paper Hunter JlazyH's Avatar
    Join Date
    Apr 2011
    Location
    Wheat Ridge, Colorado
    Posts
    191

    Default

    Tape it tight with the blue tape. Paint it with a 2 1/2 inch sash brush, don't thin the paint, and Let It Dry Comletely. The blue painters tape won't pull off the paint it's stuck too. That's why it's called "painters tape" You can leave the blue tape on for days and it won't pull the paint. Regular masking tape will. I use 3/4 inch tape and roll right down on it.
    i RIGHT i

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •