Jeepers

[10mm-man]

One shot of mine that I took yesterday. There were quite a few boulders hidden under the snow that I bashed into trying to climb up those steep climbs. It appears that I didn't break anything too serious. My tire carrier got all sorts of additional rattles yesterday from getting its ass kicked. I revamped the clamps today and so far no rattles at all. Can't wait to hit the trails again, especially next summer!

Yea, I seen you hit a few good ones thinking; I hope his lil Dana 35 holds up! Had me second guessing 35" tires and my front end. Glad she held up though!

[T-Giv]

Actually it's a 30 on the JK's. With my axle truss and gussets the front end is plenty strong for the time being. I'm more worried about blowing the ring and pinion with all of the crazy spinning I was doing. All is well though. Glad we had a great time. Can't wait for the next one dudes!

[Hitman 6]

I don't drive a Jeep but I do drive this old Land Rover. She's been all over Southern Utah and Colorado.











She's taken me to some pretty cool campsites...









...and to some nice vistas...





Through the good times and the bad...

You are one hell of a photographer, sir. Very nice work. Nice yellow thing too!

[Colorado_Outback]

I picked up this 96 Cherokee a couple weeks ago, drove it straight to the garage and started taking stuff apart. Here are some specs and pics.

4.0/AW4/NP231
3.5" RE lift
RE Adj Track Bar
33x10.50 BFG AT's
I plan on keeping it pretty mild, some bumpers and skids as I get time to fab them up. Maybe a SYE depending on how bad the vibes are once everything settles out. The PO bought and installed the lift, he did an extra shitty job. The track bar was a hot mess and nothing on the front end was torqued to spec.

[Dylan Never Sleeps]

My 2012 JK on 35's. I chopped the fender flares down to flat flares, and the front and rear bumpers down to stubby bumpers. I have a hard and soft top for it and I recently got my CB install finished up. Cheers!!


Sent from the future using a Delorean

[10mm-man]

I picked up this 96 Cherokee a couple weeks ago, drove it straight to the garage and started taking stuff apart. Here are some specs and pics.

4.0/AW4/NP231
3.5" RE lift
RE Adj Track Bar
33x10.50 BFG AT's
I plan on keeping it pretty mild, some bumpers and skids as I get time to fab them up. Maybe a SYE depending on how bad the vibes are once everything settles out. The PO bought and installed the lift, he did an extra shitty job. The track bar was a hot mess and nothing on the front end was torqued to spec.

Very nice ride!

[10mm-man]

My 2012 JK on 35's. I chopped the fender flares down to flat flares, and the front and rear bumpers down to stubby bumpers. I have a hard and soft top for it and I recently got my CB install finished up. Cheers!!


Sent from the future using a Delorean

I can't see what tires those are. Are those Nitto's? If you don't mind; How do you like em, are they good on ice? Your front bumper looks pretty good; how did you do it? These are some mods I am gonna have to do, others I have seen look pretty cut up.

[Dylan Never Sleeps]

I can't see what tires those are. Are those Nitto's? If you don't mind; How do you like em, are they good on ice? Your front bumper looks pretty good; how did you do it? These are some mods I am gonna have to do, others I have seen look pretty cut up.

The tires are Goodyear duratracs and I absolutely love them. They are fantastic on ice and snow. Really good offroad as well.

As far as the front bumper goes, when I was cutting it, I left a portion of the pieces that extend past the crush cans and cut the top and bottom off, but left the front piece of it, and then folded it over. I'll post some more photos of it if you'd like.


Sent from the future using a Delorean

[glock21]

All nice rigs. Looks like we have a few more guys to wheel with. On another note. I have a wobble at 50mph, soon as i go 5 over or under that is stops. Any ideas.

[Adawg38]

Sounds like a slight bent wheel or possibly the balancing is off. I get that at 45mph but I have 2 slightly bent rims. If it puts you into DW then you may have another issue.